From 00:37

Fill EVA cotton to the shell

From 00:50

Install Ports Board

From 01:03

The connecting piece has been connected to the battery cell by laser welding

From 01:09

Connect power wires

From 01:19

Two battery packs are connected in series

From 01:37

Lay down the battery packs

From 01:42

Put the epoxy board between the batteries

From 01:46

Fill EVA cotton to the batteries

From 02:10

Put on the shell

From 02:19

Secure shell with screws

From 02:26

Install BMS

From 03:17

Connect power wires to the shell

From 04:17

Install BMS

From 04:27

Check the signal lines in the correct order

From 04:48

Fix the temperature measuring probe near the battery pack

From 04:52

Plug signal acquisition wires’ port into the interface

From 04:55

Insert ribbon cable

From 05:02

Tidy up the wires with tie straps

From 05:10

Rearrange the wires with plastic pipes

From 05:21

Secure plastic pipe with a tie

From 05:33

Install the monitor to the cap

From 05:41

Connect the monitor to the BMS

From 05:49

Charging Test

From 05:57

Discharging Test

From 06:00

Communication Test