Start by making the work environment safe by switching off the power supply and securing the disconnection.

Disconnect the EMC filter grounding screw if you have an IT or corner-grounded TN network system.

To detach the drive press the release lever on top of the drive.

To ensure the safety of the drive system, installation of the circuit breaker is required.

Note that the conductivity of the PE conductor must match with the same cross-sectional area as the phase conductor's

Fasten the PE conductor of the input power cable under the grounding clamp.

After that, connect the phase conductor to the circuit breaker and the drive.

Pull the control cable under the grounding clamp, and tighten the clamp.

A fieldbus module is connected after the I/O connection.

Open the lock securing the disconnection and switch on the supply.