From 00:00

Introduction to Pilot Check Valves

From 00:12

List of basic hand tools required to install a pilot check valve to a hydraulic cylinder

From 00:45

Our new DIY Pilot Check Valve Install Kit

From 01:04

What a pilot check valve actually does for a Hydraulic Ram.

From 01:35

The advantages of our Pilot Check Valve Kit.

From 01:57

Metric Compression Tube fittings explained

From 03:00

Measuring the correct tube length and cutting to size.

From 05:35

Ninety (90) degree adaptors explained!

From 05:57

Fitting the long tube into the short space or gap

From 06:45

Cutting the cold-drawn seamless tube to size, "measure twice cut once"

From 07:28

CDS Cold Drawn Seamless Steel Tube Explained.

From 08:20

Remove burrs or marks on the cut tube

From 08:40

More important points about CDS tube preparation

From 09:09

Check your tube cut length again.

From 10:05

Keep things clean!

From 10:31

Fitting the cut tube to the cylinder's fittings

From 11:25

Keeping adaptors and tube in line and locking it all in place

From 12:30

Forcing the Cutting ring into the taper and onto the tube with the 5 flats formula.

From 14:20

Important check after assembly! The tube must overhang the cutting ring.

From 15:25

Conclusion

From 00:06

Cap fittings and hoses

From 00:34

Follow the recommended installation procedures.

From 00:42

Determine shimming required

From 01:04

Tighten capscrews

From 01:46

Install hydraulic option if provided

From 02:17

Install hoses

From 02:42

Flush supply hoses

From 03:08

Install forks

From 03:23

Remove fork latches

From 04:21

Inspect fork hooks, carriage bar clearance

From 00:20

4 Port Directional Control Valves

From 00:49

4-Port 2-Position Valve

From 01:47

Three Position Valve

From 02:42

Closed Centre Valve Operation

From 03:31

Float Center Valve

From 04:12

Check Valves

From 04:38

Ball & Seat Check Valves

From 05:07

Closed Center System

From 05:35

Conclusion